Andrew ATC200-Lite Guía para resolver problemas descargar pdf (Pagina 17)

Remote Electrical Downtilt System Handbook Section 2– Teletilt

RET System Components in Detail

Bulletin 639519 • Revision D May 2009 2-3

2.2 AISG RET Control Cabling

Andrew’s RET control cabling (Figure 2-4) is compliant to AISG standards and is offered in a wide

variety of lengths. Each cable has a male and a female 8–pin circular connector. These AISG compli-

ant connectors have locking screw–rings and are keyed to provide a matching ﬁ t with the ports on the

actuator, controller, and other RET devices.

Each pin is capable of supporting 5 amps. Four-way and seven-way junction boxes (Section 2.3) with

AISG compliant connectors are also available to enable up to 32 devices to be linked to the controller

using the AISG compliant RET control cabling.

See Figure 2-5 and Table 2-2 for AISG connector pin deﬁ nitions. Refer to Table 2-6a for available cable

lengths and their part numbers, as well as Andrew RET component part numbers.

Warning! Cable should never be cut to change genders.

Figure 2-4. ATCB-B01 Series AISG RET Control Cables.

ATCB-B01-R50

RET Control Cable

Jumper with Right Angle

Connector

ATCB-B01

RET Control Cable

The male connector should be attached towards the bottom end (component

output side), and the female connector should be attached at the top end

(component input side). No weather prooﬁ ng is required. Connectors should only

be hand tightened.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

Sin comentarios

Andrew ATC200-Lite Guía para resolver problemas Pagina 17