Andrew ATC200-Lite Guía para resolver problemas descargar pdf (Pagina 39)

Remote Electrical Downtilt System Handbook Section 6– ATM200-002 Actuator Issues

Bulletin 639519 • Revision D May 2009 6-3

6.5 Actuator Does Not Move to Max or Min Tilt

• See Section 6.4

6.6 Hardware Error Alarm

• When actuator is repeatedly moved to max/min tilt for many cycles in a short time, the control-

ler temporarily stops movement to prevent overheating. This is a protection, not an error. Allow

device to cool for a minute or two and retry.

If the hardware error alarm still persists, allow the device to cool for ten minutes and try to tilt

again. If the alarm still comes up, then there is an internal malfunction and the device needs to

be replaced.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 81 82

Sin comentarios

Andrew ATC200-Lite Guía para resolver problemas Pagina 39